Connecting Wires To Terminals - Kenwood Ez900HDS Instruction Manual

Connecting Wires to Terminals

Ez900HDS/Ez700SR
A Aux input
B Rear output
C Front output
D Subwoofer output
To KENWOOD disc changer/
External optional accessory
To connect these leads, refer to
the relevant instruction manuals.
If no connections are made, do not let the wire come out
from the tab.
When using the optional power amplifier, connect
to its power control terminal.
Depending on what antenna you are using, connect
either to the control terminal of the motor antenna, or to
the power terminal for the booster amplifier of the film-
type antenna.
Connect to the terminal that is grounded when either
the telephone rings or during conversation.
To connect the KENWOOD navigation system,
consult your navigation manual.
To "EXT.AMP.CONT. " terminal of the amplifier having the
external amp control function.
Car fuse box
(Main fuse)
Battery
Left output (White), Right output (Red)
A
B
C
D
Fuse (10A)
To car light control switch
To front left speaker
To front right speaker
To rear left speaker
To rear right speaker
Ignition key
switch
+ –
• Do not bend Sirius
antenna input code
strongly.
• Connection part is
fixed on vinyl tape so
that Sirius antenna is
does not come out.
P.CONT
Power control wire (Blue/White)
ANT
CONT Motor antenna control wire (Blue)
MUTE
TEL mute wire (Brown)
External amplifier control wire
(Pink / Black)
Dimmer control wire (Orange / White)
White/Black
White
Gray/Black
Gray
Green/Black
Green
Purple/Black
Purple
Car fuse
box
ACC
Ground wire (Black) - (To car chassis)
See next page for Mounting
the SIRIUS Antenna.
Sirius antenna input
FM/AM antenna input
Wiring harness
(Accessory1)
FRONT L
FRONT R
REAR L
REAR R
Ignition wire (Red)
Battery wire (Yellow)
Sirius antenna
(Accessory8)
37
|
English