Congratulations ....2 Your Here SYSTEM-H2EC Package Contents ..3 Tuner lets you enjoy SIRIUS Satellite Radio—over Safety Precautions .
Page 3
• If the LCD display becomes damaged or broken, If the problem persists, consult your Kenwood dealer. do not touch the liquid crystal fluid. The fluid may be dangerous to your health or even fatal. If the...
(Professional) Mount enclosed screws. Ask the dealer where you purchased your • Loosen the base nut on the SYSTEM-H2EC about professional installation Car Windshield Docking options. One option is to have the dealer mount Base so that the suction cup the Pivot of the Car Windshield Docking Base to portion rotates easily.
Output of the Car Cradle to the vehicle antenna to the vehicle +12V battery line. Use caution in input. Consult your car audio dealer or wiring to your vehicle’s electrical system. Kenwood professional installer for assistance. Step 4: Installing the Antenna 1.
Press the power ( ) button to turn Cat.< Here Everywhere on. Note: KENWOOD RECOMMENDS UNPLUGGING THE CIGARETTE LIGHTER ADAPTER AFTER YOU TURN OFF Presets THE VEHICLE’S IGNITION. (In some vehicles, the Display Button: Switches the display between different...
KEN.4064 H2EReceiver/Car Man 11/19/04 9:44 AM Page 12 Installing Batteries the connector at the bottom of the unit makes proper contact in the cradle. in the Remote 3. Press the power button to turn Here Note: Do not expose the remote control to high on.
KEN.4064 H2EReceiver/Car Man 11/19/04 9:44 AM Page 14 indicator (A), and the antenna signal strength indi- Direct Tuning Using the Remote cator. (When the unit is muted via the remote Mute Press the Direct button on the remote to enter Direct button, the antenna signal strength indicator is Tuning Mode.
KEN.4064 H2EReceiver/Car Man 11/19/04 9:44 AM Page 16 • If composer information is available for a 3. When the song you want to hear is highlighted, press the Control Knob (or the remote Select channel, it will be displayed along with the button) to listen to it.
KEN.4064 H2EReceiver/Car Man 11/19/04 9:44 AM Page 18 Press the Band button to change Preset banks, just • You can lock a song so that it will remain on the list as you would in Channel Tune Mode. even if you press the Menu button when 24 places have been filled.
KEN.4064 H2EReceiver/Car Man 11/19/04 9:44 AM Page 20 Press the Display button to cycle the display button will back up to the previous screen, one between the two modes. screen each press, until you exit Menu Options entirely and return to the original display. Menu Options SIRIUS ID Menu Option From the Menu Options screen, you can access...
Page 12
Kenwood recommends leaving this at the factory default level unless it is necessary to change it. The most common use for this setting is to adjust headphone volume levels if you are using Everywhere is turned off.
KEN.4064 H2EReceiver/Car Man 11/19/04 9:44 AM Page 24 screen is different in that it will stay until you press the Here Control Knob, the Menu button, or the remote Select matically picks up Universal time from the SIRIUS button. This allows you to stay in this mode while you broadcast.
5-10 seconds, then turn the power on again Turn the unit’s power off; remove it from the dock; wait 5-10 seconds; replace it in the dock and turn power back on If the problem persists, consult your Kenwood dealer...