Advertisement
The system supports two externally accessible disk drive bays on the front panel. The disk drive bays also
support RAID 0.1. Please follow the steps below to install or replace disk drives.
1. Locate the disk drive bays on the front
panel.
2. Select a drive bay for installation and
press down on the lock, the level handle
will pop open.
3. Pull the drive bay out using the lever
handle, and install a 2.5" HDD/SSD disk
drive.
Keep in mind that the contacts should be
facing outwards (bottom section of the
drive bay), towards the inside of the
system.
4. Secure the drive with four (4) screws, two
on each side.
5. Then gently slide the drive bay
completely back into its slot. Slide down
the lock key to lock the tray door.
Disk Screws
22
SATA Contact
Door Lock
Advertisement
