Graco Fire-Ball 225 Installation And Operations page 14

Closed Bung-Type-Drum,
Sturdi-Clamp-Mounted Pumps
1. Remove the adjustable bung adapter fro the pump
extension tube.
2. Screw the bung adapter (HH) into the bung hole.
3. Loosen the wing nuts (EE) and slide the clamp (DD)
onto the pump extension tube, up to the base. See
F . 10.
IG
4. Holding the clamp onto the pump, insert the pump
extension tube through the bung adapter, and lower
the pump until the clamp rests on the edge of the
drum. See F . 10.
IG
5. Install the sturdi-clamp so its upper jaw fits against
the pump base projection, its u-bolt (GG) fits around
the extension tube, and its lower jaw fits against the
bung adapter. Tighten the wing nuts (EE). See F
10.
6. Tighten the T-handle (FF) firmly to the side of the
drum.
14
DD Clamp
EE Wing Nuts
FF T-handle
. GG U-bolt
IG
HH Bung adapter
F . 10
IG
Installation
DD
EE
FF
GG
HH
Installation and Operation