Engine Shut-Off Cord (Lanyard) And Clip; Engine Stop Button; Choke Knob For Pull Type; Fuel Joint Cap - Yamaha F4 Owner's Manual

EMU25994
Engine shut-off cord (lanyard) and
clip
The clip must be attached to the engine shut-
off switch for the engine to run. The cord
should be attached to a secure place on the
operator's clothing, or arm or leg. Should the
operator fall overboard or leave the helm, the
cord will pull out the clip, stopping ignition to
the engine. This will prevent the boat from
running away under power. WARNING! At-
tach the engine shut-off cord to a secure
place on your clothing, or your arm or leg
while operating. Do not attach the cord to
clothing that could tear loose. Do not route
the cord where it could become entangled,
preventing it from functioning. Avoid acci-
dentally pulling the cord during normal
operation. Loss of engine power means
the loss of most steering control. Also,
without engine power, the boat could slow
rapidly. This could cause people and ob-
jects in the boat to be thrown forward.
[EWM00122]
3
1. Engine shut-off switch
2. Cord
3. Clip
EMU26002

Engine stop button

The engine stop button stops the engine
when the button is pushed.
1. Engine stop button
EMU26012

Choke knob for pull type

To supply the engine with the rich fuel mixture
required to start, pull out this knob.
1
1. Choke knob
EMU39722

Fuel joint cap

The fuel joint is equipped with the fuel joint
cap. WARNING! When not using a portable
1
fuel tank, make sure to install the fuel joint
cap. Otherwise, injury could result from
2
striking the fuel joint accidentally.
ZMU06725
Components
ZMU06726
ZMU06784
[EWM02411]
1
22