Troubleshooting - Titan TTT831HDC Instructions Manual

EN

Troubleshooting

Troubleshooting
Suspected malfunctions are often due to causes that the users can fix
themselves. Therefore check the product using this section. In most cases the
problem can be solved quickly.
WARNING! Only perform the steps described within these
instructions! All further inspection, maintenance and repair work
must be performed by an authorised service centre or a similarly
qualified specialist if you cannot solve the problem yourself!
Problem
1. Product does
not start
2. Product does
not reach full
power
3. Unsatisfactory
cutting result
4. Product
suddenly
stops
5. Excessive
vibration or
noise
48
Possible cause
1.1. Battery pack is not
properly attached
1.2. Battery pack is
discharged
1.3. Battery pack is damaged
1.4. Other electrical defect to
the product
2.1. Battery pack capacity is
too low
2.2. Air vents are blocked
3.1. Hedge trimmer blade is
worn / damaged
3.2. Thickness of branches
exceeds capacity
3.3. Saw chain not tensioned
properly
3.4. Saw chain is dull
damaged
4.1. Battery pack is
discharged
4.2. Battery pack is too hot
4.3. Hedge trimmer blade or
saw chain is blocked
5.1. Hedge trimmer blade or
saw chain is dull
damaged
5.2. Bolts/nuts are loosen
TTT831HDC-Li by TITAN
Solution
1.1. Attach properly
1.2. Remove and charge
battery pack
1.3. Check by a specialist
electrician
1.4. Check by a specialist
electrician
2.1. Charge battery pack
2.2. Clean the air vents
3.1. Replace with a new one
3.2. Only cut branches
complying with the capacity
3.3. Tension properly
3.4. Sharpen or replace the
saw chain
4.1. Remove and charge
battery pack
4.2. Remove battery pack and
let it cool down
4.3. Remove blockage
5.1. Replace with a new one
5.2. Tighten bolts/nuts