Table of Contents
Advertisement
TTI827HDC by TITAN
Troubleshooting
Suspected malfunctions are often due to causes that the users can fix
themselves. Therefore check the product using this section. In most cases the
problem can be solved quickly.
WARNING! Only perform the steps described within these
instructions!
All further inspection, maintenance and repair work must be
performed by an authorised service centre or a similarly qualified
specialist if you cannot solve the problem yourself!
Problem
1. Product does
not start
2. Product does
not reach full
power
3. Unsatisfactory
cutting result
4. Product
suddenly
stops
5. Excessive
vibration or
noise
Possible cause
1.1. Battery pack is not
properly attached
1.2. Battery pack is
discharged
1.3. Battery pack is damaged
1.4. Other electrical defect to
the product
2.1. Battery pack capacity
too low
2.2. Air vents are blocked
3.1. Blade is worn / damaged
3.2. Thickness of branches
exceeds capacity
4.1. Battery pack is
discharged
4.2. Battery pack is too hot
4.3. Cutting device is blocked
5.1. Blade is dull/damaged
5.2. Bolts/nuts are loosen
Troubleshooting
Solution
1.1. Attach properly
1.2. Remove and charge
battery pack
1.3. Check by a specialist
electrician
1.4. Check by a specialist
electrician
2.1. Charge battery pack
2.2. Clean the air vents
3.1. Replace with a new one
3.2. Only cut branches
complying with the
capacity
4.1. Remove and charge
battery pack
4.2. Remove battery pack
and let it cool down
4.3. Remove blockage
5.1. Replace with a new one
5.2. Tighten bolts/nuts
EN
25
Advertisement
Table of Contents
