Thermo Scientific BF51841C Operation Manual page 33

In
SPH
SPL
Upr
Dnr
tmU
AL1
AL2
HY1
HY2
SC
dr
Button
SET/ENT
Thermo Scientific
14
1200
0.0
oFF
oFF
1
9
oFF
1
0
on
0
Table 3. Push button Keypad
Function
Pressing and holding the SET/ENT for three second advances the dis-
play to the Operation Parameters Menu.
While in the Operation Parameters Menu, use SET/ENT to move from
one parameter to next, and to register changes you have made in set-
point and parameter value.
Holding SET/ENT for three seconds exits either the Operation or Setup
Parameters menu.
Use the Up Arrow button to increase the temperature setpoint display
and change parameter values in the Operation and Setup Parameter
menus. Whenever you change the value of setpoint or parameter, the
decimal point flashes to remind you to register the changed value with
SET/ENT.
Use the Down Arrow button to decrease the temperature setpoint dis-
play and to change parameter values in the Operation and Setup
Parameter menus. Whenever you change the value of a setpoint or
parameter, the decimal point flashes to remind you to register the
changed value with SET/ENT.
Input type (J thermocouple in °C;°F=44
High setpoint limit °C; °F =2192
Low setpoint limit °C; °F =32
Up ramp rate (degrees C or F / minute)
Down ramp rate (degrees C or F / minute)
Ramp Times Units,°Per minute ( 0=°Per Hour)
Alarm 1 type
Alarm 2 type
Alarm 1 hysteresis (°F=1)
Alarm 2 hysteresis
Super Control
Direct/Reverse action
Normal Controller Operation
6-3