Table of Contents
Advertisement
2
Installing the switch
CAUTION:
Keep the tamper-proof seal on a mounting screw on the chassis cover intact, and if you want to open
the chassis, contact Hewlett Packard Enterprise for permission. Otherwise, Hewlett Packard
Enterprise shall not be liable for any consequence caused thereby.
CAUTION:
Always wear an ESD wrist strap during the installation process. Make sure the wrist strap makes
good skin contact and is reliably grounded.
Figure2-1 Hardware installation flow
Start
Install the switch
Ground the switch
Install fan modules
Install power supplies
Connect power cords
Verify the installation
Turn on the circuit
breakers
Operating
correctly？
Yes
End
Troubleshoot
the switch
No
Turn off the
circuit breakers
2-6
Advertisement
Table of Contents
