Canon iP7200 Series Manual page 429

Transmission is encrypted using a network key you specified.
The security has been strengthened more than WEP.
If a network key has not been set, the Authentication Type Confirmation screen is displayed
automatically. To change network key settings before, click Configuration to display the WPA
Details screen or WPA2 Details screen.
Changing the WPA or WPA2 Detailed Settings
5. Configuration
The detailed settings screen is displayed. The network password (WEP) or the WPA/WPA2 key
selected in Encryption Method: can be confirmed and changed.
For details on WEP setting:
Changing the WEP Detailed Settings
For details on WPA or WPA2 setting:
Changing the WPA or WPA2 Detailed Settings
6. TCP/IP Setting:
Sets the IP address of the printer to be used over the LAN. Set a value appropriate for your
network environment.
Get IP address automatically
Select this option to use an IP address automatically assigned by a DHCP server. DHCP server
functionality must be enabled on your wireless LAN router or access point.
Use following IP address
If no DHCP server functionality is available in your setup where you use the printer or you want to
use a particular IP address, select this option to use a fixed IP address.
Access Points Screen
1.
Detected Access Points:
The signal strength from the access point, encryption type, name of access point, and the radio
channel can be confirmed.
Important
If you connect to a network that is not protected with security measures, there is a risk of
disclosing data such as your personal information to a third party.
Note
Signal strength is displayed as follows.
: Good
: Fair