Canon iP7200 Series Manual page 108

Do not push the sides of the ink tank. If you push the sides of the ink tank with the Y-shape
air hole (C) blocked, ink may splash.
Do not touch the inside of the orange protective cap
may stain your hands if you touch them.
Do not reattach the protective cap
local laws and regulations regarding disposal of consumables.
5.
Install the new ink tank.
(1) Insert the front end of the ink tank into the print head at a slant.
Make sure that the position of the ink tank matches the label.
(2) Press on the top of the ink tank until the ink tank snaps firmly into place.
Make sure that the ink lamp lights up red.
Important
You cannot print if the ink tank is installed in the wrong position. Be sure to install the ink tank in
the correct position according to the label on the print head holder.
You cannot print unless all the ink tanks are installed. Be sure to install all the ink tanks.
6.
Close the top cover.
Note
If the Alarm lamp still flashes orange after the top cover is closed, take appropriate action.
Alarm Lamp Flashes Orange
When you start printing after replacing the ink tank, the printer starts cleaning the print head
automatically. Do not perform any other operations until the printer completes the cleaning of
the print head. While cleaning is in progress, the POWER lamp is flashing white.
If the print head is out of alignment, as indicated by misaligned printed ruled lines or similar
symptoms, adjust the print head position.
Aligning the Print Head
The printer may make noise during operation.
(D) or the open ink port (E). The ink
(D) once you have removed it. Discard it according to the