Table of Contents
Advertisement
DIGITAL LINK:
Communication method is fixed to DIGITAL LINK.
Long reach:
Communication method is fixed to Long reach.
Modes allowing communication
: Valid
― : Invalid
Settings
For
DIGITAL
LINK
Auto
For Long
reach
For
Ethernet
DIGITAL LINK
Long reach
Note
●
When on-screen menus of the display and projector
support the DIGITAL LINK communication method
switching, the menu setting is enabled regardless of
the selector switch setting.
●
Daisy chain connection for LAN control is not
supported.
●
Models that do not support network connection do not
support LAN control.
●
When models that support serial connection use
daisy chain connection of serial control, set the head
and end of the daisy chain connection with the menu.
For details, refer to the Operating Instructions of the
display and projector.
●
Models that do not support serial connection do not
support serial control.
●
If the communication method of the twisted pair cable
transmitter is set to [Long reach], set the selector
switch to [Auto]. Then, connection is enabled with the
[Long reach] communication method.
When connecting with the separately sold DIGITAL
LINK Switcher (ET-YFB200G) with the [Long reach]
communication method, set the selector switch to
[Long reach].
●
Even if the selector switch is set to [Long reach],
when the twisted pair cable transmitter does not
support the communication method of [Long reach], it
will not be connected properly.
4
English
Communication validity
Picture
transmission Ethernet
100 m 150 m
―
―
―
―
―
―
Replacing the
terminal board
The replacement instruction below is based on the
flat panel display as an example.
For attaching or removing this product to or from the flat
panel display unit, it is recommended to ask a qualified
technician or sales dealer. A malfunction may occur due
to static electricity, etc. Consult the sales dealer.
Follow the steps below.
RS-
232C
Note
●
Be sure to turn off the display unit and connected
devices, remove the power plug from the socket, and
disconnect the cables from the display.
●
When attaching/removing the terminal board, do not
allow the metal to damage the back cover or display
label.
―
1
Remove the 2 screws, and then remove the slot
cover or terminal board from the display unit.
To remove the terminal board, hold the handle of
the terminal board and pull it out slowly in the arrow
direction.
2
Insert the terminal board to the main unit slot,
and tighten the 2 screws.
Fix the terminal board with the 2 screws removed in
step 1.
●
Tightening torque guideline: 0.5 N·m or less
Note
●
When replacing another terminal board with this
product, the customer shall keep the replaced
terminal board for future repair or servicing.
Slot cover
Screw
Advertisement
Table of Contents
