Advertisement
Thank you for purchasing your KanguruCD Duplicator from Kanguru Solutions. We are
proud of the quality and reliability of our CD-Duplication products and hope that this
product meets or exceeds your expectations.
Your KanguruCD Duplicator is designed for ease of use! It is ready to begin burning
CD's straight out of the box! Simply plug it in and follow these instructions and you will
be duplicating CDs within a matter of minutes. Enjoy!
Note - The KanguruCD Duplicator is available in two models; a stand-alone unit, and a
unit that has a USB2.0 connection. The USB2.0 model has two modes; stand-alone and
USB. The USB mode connects the duplicator's CDRW drive to you computer, which
then can be used to master CDs for duplication. The stand-alone mode is used to
duplicate CDs without being attached to a computer.
Operation Guide: Stand-Alone Mode
1. Turn on the duplicator and wait until the Ready LED turns green.
2. Open the doors of the CD-Rom and CDRW drives.
3. Insert blank media (either CD-R or CDRW) into the CD-RW Drive (bottom
drive) and then insert a Master CD into the CD-ROM Drive (top drive). Close
trays.
4. Close both Doors.
5. Press the "RUN" button.
6. If there is an error, the LED (small lights on the drives) of the CD-ROM and CD-
RW will stop flashing and both CD's will be ejected automatically at the same
time. Should this occur, please retry with a new blank CD-R or CD-RW disc in
the bottom tray. (The CD-RW Drive) If there is still an error, try another Master
CD with new blank media to determine if there is an incompatibility issue with
the Master material.
7. When duplication is complete, there the duplicator will beep and only the CD-RW
Drive will be ejected. A new copy can be started by repeating the process
beginning at step 1.
Introduction
Advertisement
