Maintenance & Cleaning - Panasonic RG-M79A Installation Instructions Manual

INSTALLATION INSTRUCTIONS (CONTINUED)
Adaptor
flanges
Blower/
motor
assembly
1
CAUTION
Before turning on the fan, make sure the connector is inserted at the correct position. Failure to properly connect
will result in fan not working.
The claw of the connector must latch to the rib completely.
WARNING
The blower/motor assembly must be tightly installed into the
housing can with the 2 screws (ST4.2X8). Failure to do so will
affect the grounding.
Install grille
1 Insert the grille assembly mounting springs into the slots as shown
and mount grille assembly to fan body.
MAINTENANCE (CLEANING)
WARNING
Disconnect power source before working on unit.
CAUTION
Routine maintenance must be done every year.
Do not immerse motor in water when cleaning. Do
not soak resin parts in water over 140ºF (60ºC).
Remove grille
1 Remove grill assembly, by squeezing the mounting springs and
pulling it down carefully.
Plug connector
Rib
Claw
2 Screws (ST4.2X8)
Fan body
Gloves
1
Never use gasoline, benzene, thinner or any other
such as chemicals for cleaning the ventilating fan.
1
Gloves
2
Slot
Mounting
spring
Grille
assembly
Slot
Mounting
spring
Grille
assembly
6