Maintenance (Cleaning) - Panasonic DV-08VRE2 Installation Instructions Manual

INSTALLATION (BETWEEN JOISTS MOUNTING) CONTINUED
13. Insert the mounting springs into the slot as
shown in the figure and attach the trim ring
to the fan body. (Fig. 9)

MAINTENANCE (CLEANING)

WARNING
Disconnect power source before working on
unit. Routine maintenance must be done
every year.
CAUTION
Never use gasoline, benzene, thinner or any other
such chemicals for cleaning the ventilating fan.
Do not immerse motor in water when cleaning.
Do not soak resin parts in water over 140 °F (60 °C).
1. Remove the trim ring by pulling down the mounting
springs. (Squeeze mounting spring and pull down
carefully.) (Fig. 10)
2. Clean the trim ring. (Don't put into hot water.
Use non-abrasive kitchen detergent, wipe dry with
clean cloth.) (Fig. 11)
3. Dry the trim ring after cleaning.
4. Remove dust and dirt from fan body using a vacuum
cleaner. (Fig. 12)
5. Using a cloth dampened with kitchen detergent,
remove any dirt from fan body. Wipe dry with clean
cloth. (Fig. 13)
6. Replace the trim ring. (Fig. 9)
MAINTENANCE (REPLACEMENT OF LED LAMP)
WARNING
Disconnect power source before working on unit.
This is a GU24 type lamp base and the lamp is fragile and heavy. Please handle with care.
Make sure the temperature of lens and lighting unit has cooled down before maintenance
(cleaning) or replacement of lamp.
1. Remove the trim ring by pulling down mounting springs.
(Squeeze mounting spring and pull down carefully.)
(Fig. 10)
2. Remove the LED lamp. (Fig. 14)
3. Replace the 11 W BR30 shape LED lamp (model:

11BR30G4DIM/927/GU24, from the company
Green Creative). (Fig. 8 of page 6)
4. Replace the trim ring. (Fig. 9)
2-Slots
1
Trim ring
2-Mounting
springs
Gloves
Gloves
2
Fig. 9
Ceiling
Trim ring
Fig. 10
Trim ring
Fig. 11
Vacuum
cleaner
Fig. 12
Gloves
Fig. 13
LED lamp
Fig. 14
7