Table of Contents
Advertisement
INSTALLATION (BETWEEN JOISTS MOUNTING) CONTINUED
12. Install the supplied LED lamp. (Fig. 9)
CAUTION
Use other lamp may result in poor
performance or risk of fire.
The supplied LED lamp is not intended for
other use.
13. Insert the mounting springs into the slot as
shown in the figure and attach the trim ring
to the luminaire body. (Fig. 10)
MAINTENANCE (CLEANING)
WARNING
Disconnect power source before working on
unit. Routine maintenance must be done
every year.
CAUTION
Never use gasoline, benzene, thinner or any
other such chemicals for cleaning the
recessed luminaire.
Do not soak resin parts in water
over 140 °F (60 °C).
1. Remove the trim ring by pulling down the mounting
springs. (Squeeze mounting spring and pull down
carefully.) (Fig. 11)
2. Clean the trim ring. (Don't put into hot water.
Use non-abrasive kitchen detergent, wipe dry
with clean cloth.) (Fig. 12)
3. Dry the trim ring after cleaning.
4. Remove dust and dirt from luminaire body using a
vacuum cleaner. (Fig. 13)
5. Using a cloth dampened with kitchen detergent,
remove any dirt from luminaire body.
Wipe dry with clean cloth. (Fig. 14)
6. Replace the trim ring. (Fig. 10)
2-Slots
1
Trim ring
2-Mounting
springs
Gloves
Gloves
LED lamp
Fig. 9
2
Fig. 10
Ceiling
Trim ring
Fig. 11
Trim ring
Fig. 12
Vacuum
cleaner
Fig. 13
Gloves
Fig. 14
7
Advertisement
Table of Contents
