Removing The Processor Heatsink Module (Phm) - Supermicro SuperServer 6019P-WT User Manual

SuperServer 6019P-WT/WTR User's Manual
Triangle on the CPU
Triangle on the
Processor Clip

Removing the Processor Heatsink Module (PHM)

Before removing the processor heatsink module (PHM), unplug power cord from the power
outlet.
1. Using a T30 Torx-bit screwdriver, turn the screws on the PHM counterclockwise to
loosen them from the socket, starting with screw marked #4 (in the sequence of 4, 3, 2,
1).
2. After all four screws are removed, wiggle the PHM gently and pull it up to remove it from
the socket.
Note: To properly remove the processor heatsink module, be sure to loosen and remove the
screws on the PHM in the sequence of 4, 3, 2, 1 as shown below. Wait for the heatsink to cool
down before removing it.
Non-Fabric CPU and Processor Clip
(Upside Down)
d
D
Heatsink
(Upside Down)
D
A
At locations A and B, the notches
snap onto the heatsink's sides
Figure 3-3. Processor Heatsink Module (PHM)
b
c
B
a
C
A
At locations C and D, the notches
snap onto the heat sink's
B
mounting holes
C
Make sure the mounting
notches snap into place
28