Summary Of Changes - MacDon New Holland FlexDraper FD2 Series Manual

Summary of Changes

The following list provides an account of major changes from the previous version of this document.
Section
1.7 Safety Decal Locations, page 8
1.8 Understanding Safety Signs, page
13
2.2 Product Specifications, page 23
Removing Outboard Flex Linkage
Covers, page 45
Installing Outboard Flex Linkage
Covers, page 46
3.8.1 FM200 Feed Auger
Configurations, page 89
Checking and Adjusting Header Float,
page 129
Changing Float Spring Configuration,
page 134
MAC215986
Summary of Change
• Added decal MAC327086.
• Superseded decal MAC313726 with
MAC360541.
• Added decal MAC360655.
• Added decal MAC327086.
• Superseded decal MAC313726 with
MAC360541.
• Added decal MAC360655.
• Added note that specifications are subject
to change without notice.
• Added FD225 specifications.
• Added skid shoes and wear plates table.
• Added header flex range table.
Edited instructions and illustrations to describe
hardware updates.
Edited instructions and illustrations to describe
hardware updates.
Added optional configuration for Case
combines to narrow feed auger.
Added IMPORTANTs. Added two WARNING
statements.
Clarified language. Added "Place the multi-
tool..." step. Added "Repeat" steps where
appropriate. Revised illustration captions.
Removed callout from transport wheels step.
Moved "each pair of bolts" note to the
relevant step. Broke out compound
adjustment bolt steps into simple steps. Added
steps for the right side of the float module.
Added sub-section headers. Added "Proceed
to..." final step.
Added float spring configuration for FD225.
Removed the topic "Changing Float Spring
Configuration – Confirming Type of Float
Lever". New headers use one type of float
lever.
ix
Internal Use Only
• ECN 58694
• ECN 63008
• ECN 63204
• ECN 58694
• ECN 63008
• ECN 63204
Technical Publications and
Product Support
ECN 63174
ECN 62924
ECN 62924
ECN 62723
ECN 62746
Product Support
Supplier Quality
Engineering
Revision A