Winegard ROADSTAR RS-3000 Instruction Manual

Winegard ROADSTAR RS-3000 Instruction Manual

Omnidirectional tv/fm antenna
Hide thumbs Also See for ROADSTAR RS-3000:

Advertisement

Omnidirectional TV/FM Antenna
www.winegard.com
For Technical Services, call 1-800-788-4417
DO NOT RETURN ANTENNA TO PLACE OF PURCHASE.
DO NOT SNAP THE ANTENNA HEAD AND PEDESTAL
TOGETHER PRIOR TO READING MANUAL.
2452249

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ROADSTAR RS-3000 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Winegard ROADSTAR RS-3000

  • Page 1 Omnidirectional TV/FM Antenna www.winegard.com For Technical Services, call 1-800-788-4417 DO NOT RETURN ANTENNA TO PLACE OF PURCHASE. DO NOT SNAP THE ANTENNA HEAD AND PEDESTAL TOGETHER PRIOR TO READING MANUAL. 2452249...
  • Page 2: Safety Recommendations

    Repair parts are available at many RV dealers and/or service centers throughout the country. If you don’t have a dealer/service center near you, call Winegard Company at 1-800-288-8094. All major credit cards accepted. If you would like to drill a hole for cable entry in any place except for directly Antenna head underneath the antenna, follow the steps on page 5 for Mounting Option 2.
  • Page 3 Mounting Option 1 Mounting Option 1 Plug the slot in the pedestal with Drill a 5/8” hole in the roof at the Check with your vehicle Before using the supplied the provided rectangular gasket. chosen location for the antenna. manufacturer for approved screws, check with your vehicle Make sure the ceiling area is sealant for your vehicle.
  • Page 4: Mounting Option

    Circular antenna, install a cable gasket entry plate (not provided) over the cable entry hole, and seal around the cable entry plate. Winegard recommends model CE-1000 cable entry plate (sold separately). Continue with installing the power supply on page 7.
  • Page 5: Installing The Power Supply

    Installing the Power Supply Installing the Power Supply, Continued Numbers in the diagrams below correspond to steps on the following page. The power supply should be turned off when connecting cables/wires. Select a location for the power supply. The power supply may be flush Front of Power Supply mounted in most standard electrical boxes.
  • Page 6: Operation

    Operation Troubleshooting Once the antenna and power supply have been installed and all cables have Do not install couplers, splitters, etc. between the power supply and the been properly connected, you must run a channel scan before watching TV in antenna.
  • Page 7 Customer must provide proof of purchase to verify the product is under warranty. If the product is brought to an authorized Winegard dealer for service prior to expiration of year one (1) of the warranty period and a defect in material or workmanship is verified by Winegard Technical Services, Winegard Company will cover the Winegard dealer’s labor...

This manual is also suitable for:

Roadstar rs-3035

Table of Contents