Operation - BorMann PRO BBP5160 Manual

EN
Installing or removing pad
(Optional accessory)
Only use hook-and-loop system pads for polishing.
To install the pad, first remove all dirt and foreign matter from the hook-and-loop
system of the pad and the backing pad. Attach the pad to the backing pad so that
their edges are aligned. To remove the pad from the backing pad, just pull up from
its edge.
Make sure that the pad and backing pad are aligned and securely at-
tached. Otherwise the pad will cause an excessive vibration which may cause loss of
control or the pad may be thrown out from the tool.

Operation

Only use BORMANN PRO genuine pads for polishing (optional accessories).
Make sure the work material is secured and stable. Falling object may cause personal injury.
Hold the tool firmly with one hand on the switch handle and the other hand on the auxiliary
handle when performing the tool.
Do not run the tool at high load over an extended time period. It may result in tool malfunc-
tion which causes electric shock, fire and/or serious injury.
Be careful not to touch the rotating part.
Before operating the tool, make sure that the auxiliary handle or hex bolt are not loose. If
the auxiliary handle or hex bolt are loose, the front cover may fall and cause an injury.
Polishing operation
8
1. Wool pad 2. Backing pad 3. Spong pad
1. Surface treatment: use a wool pad for rough finishing then use a sponge
pad for finefinishing.
2. Applying wax: use a sponge pad. Apply wax to the sponge pad or work sur-
face. Run the tool at low speed to smooth out wax.
3. Removing wax: Use another sponge pad. Run the tool to remove wax.
4. Polishing (Random orbit mode) Apply a felt pad gently to the work surface.
NOTICE: First, perform a test waxing on an inconspicuous portion of the work
surface. Make sure that the tool will not scratch the surface or result in une-
ven waxing before.
WWW.BORMANNTOOLS.COM
NOTICE: NEVER FORCE THE TOOL. Excessive
pressure may lead to decreased polishing effi-
ciency, damaged pad or shorten tool life.
NOTICE: CONTINUOUS OPERATION AT HIGH
SPEED MAY DAMAGE WORK SURFACE.
Do not apply excessive wax or polishing agent. It will generate
more dust and may cause eye or respiratory diseases.