Before Starting The Equipment; Operation - BorMann BSS1800 Translation Of The Original Instructions

The specified vibration value can be used for
initial assessment of a harmful effect.
Keep the noise emissions and vibrations to a
minimum.
• Only use appliances which are in perfect
working order.
• Service and clean the appliance regularly.
• Adapt your working style to suit the appliance.
• Do not overload the appliance.
• Have the appliance serviced whenever
necessary.
• Switch the appliance off when it is not in use.
• Wear protective gloves.
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain residual
risks cannot be rules out. The following
hazards may arise in connection with the
equipment's construction and layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear protection
is used.
3. Health damage caused by hand-arm vibrations
if the equipment is used over a prolonged period
or is not properly guided and maintained.

5. Before starting the equipment

Before you connect the equipment to the mains
supply make sure that the data on the rating
plate are identical to the mains data.
Always pull the power plug before making
adjustments to the equipment.
5.1 Dust extraction adapter (Fig. 2/Item 5)
The equipment is supplied with an integrated
dust extraction adapter (5). You need only
connect the adapter to the suitable connector of
dust collector (8).
Important.
For health safety reasons it is imperative that you
use a dust extraction system.
5.2 Securing sanding/grinding paper using a
clamp (Fig. 3-6)
Only use sanding/grinding paper of the
appropriate size and suitable perforations.
• Lift the lever (7) on the front of the orbital
sander.
• Insert the sanding/grinding paper as far as
possible into the open clamp and close the lever
again.
• Place the sanding/grinding paper taut over the
orbital plate (6) and clamp it again using the
second lever (7) on the rear of the orbital sander.
• Make sure that the perforations in the
sanding/grinding paper line up with the
oscillating plate.

6. Operation

6.1 Switching the machine on and off
(Fig. 7/Item 2)
To switch on:
Slide the operating switch (2) forwards.
To switch off:
Slide the operating switch back into its initial
position
15