Cutter Guard; Feather Board; Handwheel Handle; General Information - Jet JWS-35X Series Operating Instructions And Parts Manual

Jet jws-35x shapers: user guide
Hide thumbs Also See for JWS-35X Series:
Table of Contents

Advertisement

Cutter Guard

Referring to Figure 2:
Mount the cutter guard (A) to the safety guard
holder (H). Insert two lock knobs (B) through the
cutter guard slots and into the threaded mounting
holes (J) on the safety guard holder (H).

Feather Board

Referring to Figure 2:
Loosen lock handles (C) and slide the rail of the
featherboard so the squared edges of the
carriage bolt (D) engages in the groove (F) along
the top of the fence.
Figure 2

Handwheel Handle

Insert the handle (A, Fig. 3) into the handwheel
(B) and secure with a 14 mm wrench.
Electrical connections must
be
made
by
a
qualified
compliance with all relevant codes. This
machine must be properly grounded to help
prevent electrical shock and possible fatal
injury.

General Information

A power plug is not provided with the Model
JWS35X. You may either connect the proper
UL/CSA listed plug or "hardwire" the machine
directly to your electrical panel provided there is a
disconnect near the machine for the operator.
Consult electrical drawings on pages 45-46 for
further clarification of wiring setup.
This machine must be grounded. Grounding
provides a path of least resistance to help divert
current away from the operator in case of
electrical malfunction.
Make sure the voltage of your power supply
matches the specifications on the motor plate of
the machine.

Extension Cords

If an extension cord is necessary, make sure the
cord rating is suitable for the amperage listed on
the machine's motor plate. An undersize cord will
cause a drop in line voltage resulting in loss of
power and overheating.
The chart in Table 1 shows the correct size cord
to use based on cord length and motor plate amp
rating. If in doubt, use the next heavier gauge.
The smaller the gauge number, the heavier the
cord.
Extension Cord Length *
25
50
Amps
feet
feet
< 5
16
16
5 to 8
16
16
8 to 12
14
14
12 to 15
12
12
15 to 20
10
10
21 to 30
10
NR
*based on limiting the line voltage drop to 5V at 150% of the
rated amperes.
NR: Not Recommended.
Table 1
10
electrician
in
75
100
150
200
feet
feet
feet
feet
16
14
12
12
14
12
10
NR
12
10
NR
NR
10
10
NR
NR
10
NR
NR
NR
NR
NR
NR
NR

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Jws-35x3-1Jws-35x5-1Jws-35x5-3

Table of Contents