Error Messages; Clean The Sensor Filter - Hasselblad X2D 100C User Manual

User Manual
X2D 100C
5.2

ERROR MESSAGES

If any error message is displayed
1. Remove the components from the camera.
2. Attach the components to the camera again.
If the error message is still displayed
1. Remove the battery.
2. Remove any connected USB cable.
3. Wait 10 seconds.
4. Attach the battery again.
The camera processor is now reset.
If the error message is still displayed
1. Write down the error message.
2. Contact your closest authorized Hasselblad dealer.
5.3

CLEAN THE SENSOR FILTER

Follow the instructions below:
1. Power off the camera and remove any cable if connected.
2. Press and hold the lens release button. Rotate the lens counterclockwise to remove it.
3. Carefully clean the outside surface of the IR filter by using clean compressed air.
Take several shots of multiple images to test and check each image carefully. Contact the
Hasselblad authorised service centre if there are any spots on the images.
• Be careful when attaching/removing the components to/from the camera. This will help
prevent damage to the data bus connections.
• After removing the lens, keep foreign objects away from the camera opening. The camera
opening is very sensitive. This will help prevent damage to the equipment.
• If using canned compressed air to clean the glass of the IR filter, read the instructions
carefully before use. This will help prevent damage to the filter.
CONTENTS
113