Table of Contents
Advertisement
User Manual
CFV 100C
5.2
ERROR MESSAGES
If any error message is displayed
1. Remove the components from the camera.
2. Attach the components to the camera again.
If the error message is still displayed
1. Remove the battery.
2. Remove any connected USB cable.
3. Wait 10 seconds.
4. Attach the battery again.
The camera processor is now reset.
If the error message is still displayed
1. Write down the error message.
2. Contact your closest authorized Hasselblad dealer.
5.3
CLEAN THE SENSOR FILTER
Follow the instructions below:
1. Power off the camera and remove any device or cable, if connected.
2. Detach the digital back from the connected device.
3. Carefully clean the outside surface of the IR filter using canned compressed air.
4. Mount the digital back to the camera or mount the protective covers to the digital back
and camera.
Take several shots of multiple images to test, and then check each image carefully. Contact
the Hasselblad authorised service centre if there are any spots on the images.
• Be careful when attaching/removing the components to/from the camera. This will help
prevent damage to the data bus connections.
• After removing the lens, keep foreign objects away from the camera opening. The camera
opening is very sensitive. This will help prevent damage to the equipment.
• If using canned compressed air to clean the glass of the IR filter, read the instructions
carefully before use. This will help prevent damage to the filter.
• DO NOT remove the glass IR filter from the front of the sensor. This will cause damage to
the equipment. Contact the Hasselblad authorised service centre if needed.
CONTENTS
133
Advertisement
Table of Contents
