Locating; Renaming The Handset; Setting The Eco Mode - Yealink One Talk W78B User Manual

Procedure
1. Go to Menu > Basic Settings > Change PIN
2. Enter your old and new unlock PIN respectively
The unlock PIN length must be within 15 digits
3. Confirm the action

Locating

You can locate a misplaced registered using the base station.
Procedure
1. Press on the base station
All the handset that registered to this base station will ring simultaneously and the screen will display the IP address of the base station
You can press any key on handset to stop ringing (For CP930W, tap the
Note: When the handsets are not in the idle status, they will not ring simultaneously.

Renaming the handset

The handset will be named automatically if successfully registered to the base station. You can personalize the handset name.
Procedure
1. Go to OK > Settings > Handset Name
2. Edit the current name in the Rename/Phone Name field
3. Confirm the action

Setting the eco mode+

Eco mode+ turns off the transmission power and the radio waves emitted are virtually zero when the phone is in standby mode.
About this task
You can enable or disable the eco mode+. If the eco mode+ is enabled, there is no signal interaction between the handset and the base station, and
the color of the signal strength indicator on the idle screen will be displayed in green. When a call arrives or a connection occurs, the phone exits
the eco mode+ automatically, and the color of the signal strength indicator on the idle screen changes from green to white.
Procedure
1. Go to OK > Settings > System Settings > Eco Mode+
2. Press Change
3. Enter the system PIN (default: 0000) and then press Done. The phone prompts whether to reboot the base station
4. Confirm the action
The base station reboots to make the change take effect. The change applies to all the handsets registered to the base station. The color of
the signal strength indicator on the idle screen will change from white to green
Setting the eco mode
Using the eco mode can greatly reduce the transmission power and signal output when the handset is during a call.
The attenuation range is 20m. When the distance between the base station and the handset is over 20m, the eco mode is disabled automatically. If
the eco mode is enabled, the radio coverage of the base station will be reduced.
Procedure
, , OK key and the End Call
User guide
38