Handset Settings; Screen Saver; Changing The Brightness; Setting The Keypad Light - Yealink HORIZON W73P User Manual

Handset Settings

Screen Saver

The screen saver is designed to protect your phone screen. When the screen saver is enabled, an
analogue clock will be activated and appear on the phone screen if the handset is idle for
approximately 10 seconds.
1. Go to OK > Settings > Display > Screen Saver.
2. Press Change to select the Screen Saver check box (the default status is checked).

Changing the Brightness

When in charger/out of charger is enabled, the backlight will be turned off after the handset is idle
for about 30 minutes when the handset is or is not in the charging cradle. When an incoming call
arrives, a key is pressed or the handset status changes, the backlight is automatically turned on.
1. Go to OK > Settings > Display > Display Backlight.
2. Select the desired value from the Active Level field.
3. Select the desired value from the In Charger or Out Of Charger field.
4. Confirm the action.

Setting the Keypad light

You can enable the keypad light to illuminate the keypad keys when any key is pressed.
1. Go to OK > Settings > Display > Keypad LED.
2. Press Change to select the Keypad LED check box (the default status is checked).

Locking / Unlocking the Handset

You can lock the device so that you can prevent accidental user of the handset. To do this, long
press the # key whilst the handset is idle until the phone prompts you that the device is locked. To
unlock the handset, simply long press # again until the handset prompts you that it is unlocked.

Locating a Handset

You can locate a misplaced registered using the base station by pressing the
base station.
Horizon / Yealink W73P User Guide
button on the
16