Table of Contents
Advertisement
5.3.9 Configuration of the Flood Detector
Back to Contents
•
The number of RFID chips previously paired is displayed on
the control panel.
•
If the pairing of the chip was unsuccessful, a single long signal
tone is emitted.
•
To exit the settings, press the settings button again.
Note
A maximum of eight RFID chips can be paired.
Unpairing an RFID chip
•
Press the settings button
•
Enter the PIN code within the next 10 seconds. (Default PIN
code 1234)
•
Then press button (2).
•
Hold the required RFID chip in front of the LED below the
control panel within 30 seconds.
•
Successful unpairing is confirmed by two consecutive signal
tones.
•
The number of RFID chips that are still paired is displayed on
the control panel.
•
To exit the settings, press the settings button again.
Select the components you want to configure from the component
overview.
Name
Enter a name for the component.
Room
Open the room list and select the room where the Flood Detector
is installed. Tap the arrow
64
on the control panel.
to return to the settings.
Back to Contents
English
Advertisement
Table of Contents
