Table of Contents
Advertisement
•
You can either install the magnetic contact on the top or the side of the window. If you install the
magnetic contact on the underside of the window, the magnetic contact may not trigger if the
window is tilted (not recommended).
Installation with adhesive pads
1. Stick both the small adhesive pads on to the magnetic contact's large transmitter components and
the longer adhesive pad on to the smaller magnet component.
2. Stick the large transmitter component to the window frame in the desired position in relation to the
window and stick the smaller magnet component to the window itself.
3. Please clean the areas where you would like to attach the adhesive pads first.
Installation with screws (recommended)
1. Open the magnetic contact's smaller magnet component with a thin slotted screwdriver.
2. Remove the battery compartment cover from the magnetic contact's larger transmitter component.
3. Screw the smaller magnet component in the desired position on the window using two screws.
You must first break through the intended holes using a screwdriver or drill.
4. Screw one screw into the window frame for the transmitter component's keyhole fitting.
5. Attach the transmitter component and fix to the window frame with the remaining screw.
Further information on the magnetic contact
Description
Back to Contents
Programming
Removal
Configuration
33
English
Technical data
Back to Contents
Advertisement
Table of Contents
