Table of Contents
Advertisement
3.10
FUBE35020 Wireless Button
Note
The Wireless Button is only suitable for indoor use. For further information, please refer
to the safety instructions relating to installation location and operating environment.
Drill installation using bracket
1. With the help of the bracket, mark two bore holes on the wall ("UP" denotes which way is up).
Drill holes in the specified positions and insert the screw anchors provided. Affix the bracket to
the desired installation location using the screws supplied.
2. Now slide the Wireless Button onto the bracket so that the slots are positioned on top of the
corresponding bracket hooks. Now slide the Wireless Button downwards until the bracket clicks
into place.
3. To remove the Wireless Button from the bracket again, gently press the locking pin downwards
and slide the Wireless Button upwards off the bracket.
1
Adhesive installation
•
Please thoroughly clean the area where you would
like to attach the adhesive pad first.
•
Attach the supplied adhesive pad to the underside
of the Wireless Button.
•
Secure the Wireless Button in the desired position
(on an even surface).
Further information on the Wireless Button
Description
Back to Contents
Programming
2
Removal
Configuration
39
English
3
Technical data
Back to Contents
Advertisement
Table of Contents
