Table of Contents
Advertisement
Back to Contents
Hotkeys
There are two pre-configured hotkeys – panic and camera –
below the status display, which you can tap and enable in the
overview. These two hotkeys are also found on the FUBE35000
Remote Key and can be operated from there.
Standard:
All actuators are triggered (e.g. sirens) and all
cameras are recording
Standard:
All cameras are recording
Note
When pairing components, standard values are
automatically set for the pre-configured hotkeys.
Should you wish to alter the settings for the hotkey in
question, you can find the settings under
Hotkeys.
Fault
Should any faults occur (e.g. battery dead), these are shown
below the hotkeys. Once the faults have been remedied, they are
no longer shown in the overview.
You can also find the fault messages in the
Active devices
Components with an active status (e.g. wireless socket "on") are
displayed in a list. Once the components are deactivated, they are
no longer shown in the overview.
This means you always have an overview of any devices
consuming power.
45
English
Section 5.4
Event Overview (4.7).
Back to Contents
Advertisement
Table of Contents
