Amp - Korg wavestate native User Manual

Synthesis page
Time
[0.0000...50.0000 secs or secs/octave]
This controls the portamento time. If Type is set to Constant Rate, the units are secs/octave (seconds per octave). If
Type is set to Constant Time, the units are simply secs (seconds).
Pitch Bend Range
Up
[–60...+60]
This sets the maximum amount of pitch bend, in semitones, when you move the wheel above the center point. For
normal pitch bend, set this to a positive value.
Down
[–60...+60]
This sets the maximum amount of pitch bend, in semitones, when you move the wheel below the center point. For
normal pitch bend, set this to a negative value.

Amp

Notes on Amp Modulation
Amp modulation scales the Amp Level and Amp Envelope, with an upper limit of 2x the original settings to prevent
uncontrollably loud output. If the original level is low, the maximum modulated volume will also be low.
(For the technically inclined: Amp modulation is multiplicative. Modulation values are offset by +1.0, so that a value
of 0 has no effect. The maximum modulation value—for example, moving the Mod Wheel all the way up—doubles the
volume level if the Intensity is +100%, or brings the level to silence if the Intensity is -100%.)
Tip: To start with a low level (or silence) and then use modulation to raise the level to maximum, use the Filter Output
Level instead.
Level
[0%...100%]
This sets the basic volume of the Program, optimized for per-voice modulation. For adjusting the volumes of Programs
within a Performance, it's better to use the Layer Volume instead.
Amp LFO Intensity
[–100%...+100%]
This controls the amount of modulation from the Amp LFO.
Velocity
[–100%...+100%]
With positive (+) values, the volume increases as you play harder.
With negative (–) values, the volume decreases as you play harder.
Key Track
[–100%...+100%]
This adjusts the intensity of Key Track's effect on the level.
Pan
Pan
[L100...L1, C0, R1...R100]
This sets the left-right pan. Note that this can be modulated per voice!
Pan LFO Intensity
[-200...+200]
This controls the intensity of Pan modulation from the Pan LFO.
25