Routine Maintenance - Roborock Q7 Q400RR User Manual

Reset button until you hear the "Restoring
factory settings" voice prompt.
Do Not Disturb (DND) Mode
The default Do Not Disturb (DND) period is
from 22:00 to 08:00. You can use the app to
disable the DND mode or modify the DND
period. When DND mode is activated, the
robot will not automatically resume cleanup,
the power indicator light will dim, and the
volume of the voice prompts will lower.
Refilling the Water Tank or
Washing Mop
To add water or clean the mop cloth, press
any button to stop the robot and remove
the mopping module. After adding water
or cleaning the mop cloth, reinstall the
mopping module and press the
to continue.
App Features
Cleaning Map
• Multi-map management
• Real-time vacuum and mop route
• Map zoning
• Map editing
Custom Cleaning Modes
• Scheduled Cleaning
• Selective Room Cleaning
• Zone Cleaning
• No-go zones & invisible wall
• Custom modes
• Carpet Boost
Cleaning Mode Switch
• 4-level suction power
Robot Information
• Cleaning history
• Battery level
• Care & maintenance
More Features
• Firmware upgrade
• Volume adjustment
• DND mode
• Voice assistance support
Note: Features and details of the app may vary slightly due to
the continuous app development and updates.
button

Routine Maintenance

C
Main Brush
C1
*Clean every 2 weeks and replace every 6-12 months
C1-1—Main Brush Cover
C1-2—Latches
C1-3—Main Brush
C1-4—Main Brush Caps
C1-5—Main Brush Bearing
C1-6—Turn over the robot and press the
latches to remove the main brush cover.
C1-7—Pull out the main brush and remove
C1-8—Rotate the main brush caps in
C1-9—After removing the tangled hair
C1-10—Make sure that the main brush cover
Notes:
• Main brush should be wiped down with wet cloth and left to
dry away from direct sunlight.
• Do not use corrosive cleaning fluid or disinfectant to clean
the main brush.
C2
*Clean every month and replace every 3 to 6 months
1. Unscrew the side brush screw.
2. Remove and clean the side brush.
C3
*Clean as needed
C3-1—Use a tool, such as a small
Note:
14
the main brush bearing.
the indicated unlock direction to remove
the caps.
or dirt at both ends of the main brush,
reinstall it, press on the main brush cover
to lock it in place.
has been properly attached. When properly
installed, all four tabs should be hidden.
Side Brush
Reinstall the brush and tighten the screw.
Omni-Directional Wheel
screwdriver, to pry out the axle and take
out the wheel.
The omni-directional wheel bracket cannot be removed.