Related Manuals for Roborock Q7+
Summary of Contents for Roborock Q7+
- Page 1 Roborock Q7+ Robotic Vacuum Cleaner User Manual Read this user manual with diagrams carefully before using this product and store it properly for future reference.
- Page 2 English Français Español...
-
Page 3: English Contents
English Contents WARNING Battery and Charging International Symbols Explanation FCC/IC Statement Product Overview Installation Connecting to the App Instructions for Use Routine Maintenance Environment Protection Information Basic Parameters Errors FAQs... -
Page 4: Battery And Charging
WARNING • For use only with roborock CDZ11RR, CDZ12RR, AED03LRR or AED04LRR charger. • Place the cords from other appliances out of the area to be cleaned. • Do not operate the vacuum in a room where an infant or child is sleeping. -
Page 5: Fcc/Ic Statement
(1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device. Correspondence of the responsible party in USA Company Roborock Technology Co. Address 108 West 13th Street, Wilmington, Delaware 19801. Email support@roborock.com... -
Page 6: Product Overview
Product Overview Robot (Upper Cover Open) Auto-Empty Dock A3-1—WiFi Indicator Light A9-1—Dustbin Cover Robot (Top View) A9-2—Dustbin (Disposable Dust Bag • Off: WiFi disabled • Flashing slowly: Waiting for connection Pre-Installed) —Power/Clean • Flashing quickly: Connecting A9-3—Status Indicator Light • Press and hold to turn the robot on •... -
Page 7: Connecting To The App
WiFi then turn on. B2-4-1—More than 0.5m (1.6ft) B4-2—Fill the water tank The robot supports the Roborock and Mi B2-4-2—More than 1.5m (4.9ft) Remove the water tank stopper, fill it with Home app. Choose the one that best meets B2-4-3—More than 1m (3.3ft) - Page 8 ❸ Add device Zone 1 – Cleaned Zone 2 – Cleaned Option 1: Search for “Roborock” in the App Open the Roborock App, tap the “Search for Store or Google Play or scan the QR code to device” button, or open Mi Home app, tap “+”...
- Page 9 Resetting App Features Notes: • The robot will not go to sleep when it is charging. • The robot will automatically shut down if left in sleep mode If the robot does not respond when a Cleaning Map for more than 12 hours. button is pressed or cannot be turned off, •...
-
Page 10: Routine Maintenance
Routine Maintenance Omni-Directional Wheel Mop Cloth * Clean as needed * Clean after each use and replace every 3 to 6 months Main Brush C3-1—Use a tool, such as a small C6-1—Remove the mop cloth from the screwdriver, to pry out the axle and mopping module. -
Page 11: Basic Parameters
Environment C8-4—Install a new dust bag in place along the Basic Parameters slot and put the dustbin cover back. Protection Information Robot Air Duct * Replace as needed. Removing the Battery C9-1—Unscrew the screws (10) and remove Model Q400RR the cover. * The following information applies only when disposing 14.4V/5200mAh Battery... - Page 12 Error 4: recommendations in the table above, contact our move robot away from drops and restart. support team at: Main brush jammed. Clean main brush support@roborock.com (United States/Canada/ Error 5: and bearings. Non-Europe) 1-855-960-4321 (United States only) Side brush jammed. Remove and clean...
- Page 13 Unable to connect to WiFi • Current device not supported. Find the supported models in the app. • Unable to connect to WiFi. There may be an error with your router settings. Contact Roborock Customer Service for help with troubleshooting.
- Page 14 FAQs Problem Solution Scheduled Cleaning is not working • Battery low. Scheduled Cleaning can only begin when the battery level is above 20%. Is power always being drawn when • The robot will draw power while it is docked to maintain battery performance, but the robot is on the dock? the power consumption is extremely low.
- Page 15 FAQs Problem Solution • The dustbin cover is not in place. Check and correct installation. • The fan is not operating properly. Potentially due to overheating protection resulting Red LED indicator on from frequent starting and stopping. Unplug the power cable and try again after 30 the Auto-Empty Dock minutes.
Need help?
Do you have a question about the Q7+ and is the answer not in the manual?
Questions and answers