Kts Truck Licensing; Bluetooth Setup; Bluetooth Driver Installation - Bosch KTS Truck Original Instructions Manual

en 24 | KTS Truck | Commissioning
4.2

KTS Truck licensing

1. Connect KTS Truck to a PC/Laptop via the USB
connecting cable.
2. Start ESI[tronic] 2.0 either by way of "Start
>> All Programs >> Bosch ESI[tronic] 2.0 >>
ESI[tronic] 2.0" or with a double click of the left
mouse key on the icon
« The following message appears after a brief delay:
3. Select <Licensing>.
i
Licensing is performed by file or online. You can find
further information in the Online Help opened with
.
|
1 689 989 100 2013-03-11
.
4.3

Bluetooth setup

In the case of a PC/Laptop without internal Bluetooth
hardware, Bluetooth driver installation must be per-
formed for the Bluetooth USB adapter supplied (refer
to Section 4.3.1).
The Bluetooth USB adapter supplied is not required
for a PC/Laptop (e.g. DCU 130) with internal Bluetooth
hardware and the Bluetooth driver does not have to be
installed.
The KTS Truck MAC address must however be entered
in ESI[tronic] 2.0 in both cases (refer to Section 4.3.2).
i
For a PC/Laptop with Bluetooth Class 2 it is advis-
able to make use of the Bluetooth USB adapter sup-
plied (Class 1) as this provides a better range (refer
to Section 7.3).
i
The procedure is described on the basis of the
"WIN 7" operating system. The procedure may differ
for other systems.
4.3.1

Bluetooth driver installation

i
It is not possible to operate any other item of Blue-
tooth hardware fitted or plugged into the PC/Laptop,
as this would interfere with data communication
between KTS Truck and the control unit.
i
Before starting up the Bluetooth USB adapter, the
Bluetooth hardware integrated into the PC/Laptop
(e.g. Widcomm Stack/Toshiba Stack) must be deac-
tivated (refer to the PC/Laptop operating manual).
In addition, the corresponding Bluetooth driver
must be de-installed (remove Bluetooth driver under
"Start >> Control panel >> Software").
i
If the Bluetooth USB adapter is to be used in differ-
ent PC/laptop USB ports with the WIN XP operating
system, the Bluetooth driver must be installed for
each USB port.
i
Do not plug the Bluetooth USB adapter into the
PC/Laptop until requested to do so during Blue-
tooth driver installation (Message: Connect Blue-
tooth device). Plugging in the Bluetooth USB adapter
beforehand will result in opening of the Windows
hardware assistant. The Windows hardware assist-
ant must then be shut down and the Bluetooth USB
adapter removed.
Robert Bosch GmbH