Mitsubishi MELSEC Q Series User Manual page 16

2 SYSTEM CONFIGURATIONS
2
2 - 2
(b) Mounting to a MELSECNET/H remote I/O station
The following shows the mountable network modules, No. of mountable
modules, and mountable base unit of the QD62 (E/D) module.
Power shortage may occur depending on the combination with other
mounted modules or the number of mounted modules.
When mounting modules, pay attention to the power supply capacity.
When the power shortage occurs, review the combination of modules to be
mounted.
Mountable network No. of mountable
module 3
QJ72LP25-25
QJ72LP25G
QJ72LP25GE
QJ72BR15
1: Limited to the range of the number of I/O points in the network module.
2: Mountable on any I/O slot of the mountable base unit.
3: The coincidence detection interrupt function is not supported.
REMARK
The Basic model QCPU cannot create the MELSECNET/H remote I/O network.
(2) Support of the multiple CPU system
When using the QD62 (E/D) in a multiple CPU system, refer to the following
manual first.
• QCPU User's Manual (Function Explanation, Program Fundamentals)
If the QD62 (E/D) is used in a multiple CPU system, there are no restrictions
depending on the module version.
Write intelligent function module parameters to only the control CPU of the QD62
(E/D).
Main base unit of
modules 1
remote I/O station
Up to 64
MELSEC-Q
Mountable base unit 2
Extension base unit of
remote I/O station
: Mountable, : Not mountable
2 - 2