Advertisement
2. The grounding terminal of the machine shall be grounded reliably, its section ≥2.5
2
mm
.If many machine is working at the same time, a equipotential device should be
equipped between each set.
3. During the conveyance of the machine, the vibration will cause the loose or removal of
the spare parts, so when installation and debugging, please tighten each loosening parts.
4. Pour oil before heating, and its oil level can't be lower or higher than the oil level line.
It is forbidden to heat if there is no oil in the boiler, otherwise the electro thermal pipe
will be burned out.
5. The temperature is set between 150℃and 180℃, the user can set it depending on the
production, timing set, cold oil to heat for 20 to 30 min, hot oil to fry 10 to 15 min,
before frying the food, the oil temperature must be over 150℃.
6. When cold oil heating, you'd better not lid the cover. Mix up manually the oil
continuously to heat it fast and well-proportioned.
7. When its delivery, the pressure of the automatic overflow valve is usually set at
0.07Mpa to 0.08MPa, if the indication of the pressure gauge exceeds 0.09MPa and
continues to increase, discharge the air manually, and unbolt moderately the air-release
valve to discharge the air, making the air pressure keep at 0.08Mpa to 0.09Mpa.
III. Operation Principle and Process
1. Preparation before starting the machine and the process for frying
Before you turn on the ON switch, you must open the fryer lid to pour at least 25L oil into the pot.
(When you pouring the oil, looking at the oil line===, to make sure it is suitable to be higher 10mm than
the heaters).Be careful, before you pouring the oil into the pot, you should open the door at the bottom
side to check the oil drain valve and oil filter valve to make sure that it is in be closed. After checking
this, close the door at the bottom to connect the power to start the machine.
Turn the power switch on to the Heating Position(Power), and set the temperature controller. Turn
on the timer, set the time, and turn off the drain valve at the same time. Now the machine starts heating
and the oil inside heating now. When the temperature is not reach to the working temperature, please do
2
Advertisement
