Table of Contents
Advertisement
The screen lights and the Penware 1500 logo displays for 3 seconds.
The green LED blinks while the terminal is searching for the host, then turns solid
green when the host is found.
Note: To enable the terminal to recognize the host, install and run the
PenWare Initialization Program located on the PenWare Utilities
Diskette. This program tests the host and terminal connection, and
calibrates the signature pad if necessary. See the
Initializing the PenWare 1500
PS/2 Installation
To install the PenWare 1500 in a PS/2 cable configuration:
1. Shut off power on the POS host device.
2. Plug the serial cable's 15-pin connector (HDB15) into the RS-232 port on the back
of the PenWare 1500.
3. Plug the serial cable's 9-pin connector (DB9) into a serial port (typically COM1) on
the POS host device.
4. Plug the single lead on the PS/2 cable into the host's mouse port.
5. Connect the mouse to the shorter PS/2 lead on the two-lead side.
6. Insert the remaining lead into the port on the back of the serial cable's 9-pin
connector (DB9).
Setting Up the PenWare 1500 System
for more information.
Chapter 3,
2-3
Advertisement
Table of Contents
