Diting; Edit To Or From Another Vcr - JVC HR-J456EN Instruction Manual

EDITING
Edit To Or
From Another
VCR
Player
AUDIO OUT
VIDEO IN
Recorder
VCR
1
NUMBER "1"
4
7
1
STOP
Your VCR
PAUSE/
AV
COMPU
-LINK
VIDEO OUT
Audio/Video Cable
(not supplied)
AUDIO IN
Another VCR
POWER
NUMBER "2"
2 3
2
5 6
8 9
0
4
You can use your VCR as the player or the recorder.
MAKE CONNECTIONS
1
Connect an Audio/Video cable between your VCR's VIDEO
OUT and AUDIO OUT connectors and another VCR's
VIDEO IN and AUDIO IN connectors.
For HR-J656EN...
When connecting to a monaural VCR, connect your
VCR's AUDIO OUT L connector to the AUDIO IN
connector on the monaural VCR.
For HR-J456EN...
When connecting to a Hi-Fi VCR, connect your VCR's
AUDIO OUT connector to the AUDIO IN L connector
on the Hi-Fi VCR.
LOAD CASSETTES
2
Insert the playback cassette into your VCR and the cassette
to be recorded on into the other VCR.
SET RECORDER'S INPUT MODE
3
Set to "AUX". With this VCR, press the NUMBER key
"0" and/or CH 5 ∞ (+/–) to select depending on the
connector being used – "L-1" for the rear AUDIO/
VIDEO IN connector, or "F-1" for the front AUDIO/
VIDEO IN connector. (You can only select "F-1" for
HR-J456EN.)
START PLAYER
4
Set to its play mode.
NOTE:
If the player is equipped with a superimpose/OSD
disable feature then set "SUPERIMPOSE" to "OFF"
before pressing PLAY (
START RECORDER
5
Set to its record mode.
Control Two JVC VCRs
The remote control is capable of controlling two JVC VCRs
independently; one set to respond to your remote control's A code
control signals and another set to respond to B code control
signals. The remote control is preset to send A code signals
because your VCR is initially set to respond to A code signals. You
can easily modify your VCR to respond to B code signals.
1 Unplug the VCR's power cord from the AC outlet.
2 While holding down VCR on the remote control, press the
NUMBER key "2" and then press STOP.
3 Plug the VCR's power cord back into the AC outlet.
4 Press POWER on the remote control to turn the VCR's power
on.
The VCR will now respond only to B-code commands.
To set the VCR back to respond to A code signals, repeat the same
procedure as shown above except pressing NUMBER key "1"
instead of "2" in step 2.
You can control two VCRs with the same remote control by
switching the remote's code between A and B.
33
EN
pg. 20).