Roland TurboStart VS-880 Supplemental Notes page 19

NQPSMTR
All Other SDE
SDX-330
SE-50
SE-70
SH-Series
SN-700
SP-700
SPD-8
SPD-11
SRC-2
SRV-330
SRV-1000
SRV-2000
SSC-8004
STUDIO M
SUPER JUPITER
SUPER JX keybrd. (Same as JX-10.) No ROM reset.
SUPER JX module (Same as MKS-70.) No ROM reset.
SUPER QUARTET (Same as MKS-7.) No ROM reset.
All SYNTH PLUS
SX-700
TB-303
TD-5
TD-7
TD-10
TL-Series
TP-20
TR-505
TR-626
TR-707
TR-727
© 1997 Roland Corporation U.S.
No ROM reset.
Power on while holding SYSTEM and PROGRAM. Use the DATA dial to select SYSTEM
+ PROGRAM. Press MEMORY.
Power on while holding PARAM UP (^) and VALUE UP (^). Press WRITE. Wait three
seconds and press WRITE again.
Power on while holding in the NUMBER/VALUE knob. Press PARAMETER LEFT (<),
then dial to STANDARD mode or GUITAR mode. Press WRITE.
No ROM reset.
No ROM reset.
No ROM reset.
Power on while holding EDIT, then press COPY. Use the VALUE UP (^) and DOWN (v) to
select F A L in the window. Press ALL/ENTER.
Power on while holding ALL/ENTER and DOWN (the solid v). Press ALL/ENTER again.
No ROM reset.
Power on while holding SYSTEM and PROGRAM. Use the DATA dial to select SYSTEM
+ PROGRAM. Press MEMORY.
No ROM reset.
Factory: Power on while holding WRITE and REVERB NON-LINEAR.
Delay Mode: Power on while holding WRITE, REVERB NON-LINEAR and ROOM
SIMULATE.
No ROM reset.
(Same as MV-30.) No ROM reset.
(Same as MKS-80.) No ROM reset.
(Same as HS-Series.) No ROM reset.
Press UTILITY. Use PARAMETER LEFT (<) and RIGHT (>) to select FACT INIT. Press
WRITE.
No ROM reset.
Power on while holding EDIT and START/STOP, then press START/STOP again.
Press SYSTEM. Use the LEFT (<) and RIGHT (>) CURSOR buttons to select INI, then
press ENTER. Cursor to HI HAT and use the DATA dial to select ALL. Press ENTER
twice.
Press SETUP, then press F4 three times.
No ROM reset.
No ROM reset.
Power on while holding MODE and PATTERN GROUP KEY A .
Power on while holding MODE and TRACK #1.
Power on while holding TRACK WRITE and TRACK #1 .
Power on while holding TRACK WRITE and TRACK #1 .
Re-initialization Procedures
Supplemental Notes
Page 8 of 9