Removing The Transport Safety; Devices; Installation Site - Hanseatic HWMK814A User Manual

Page EN-34 Installation, connection and initial commissioning
Removing the transport
safety devices
WARNING
Risk of electric shock!
Touching live parts may result in severe
injury or even death.
■ Make sure the appliance is not con-
nected to the power supply whilst the
transport safety devices are being re-
moved or installed.
There are four transport safety devices on the
back of the device. These must be removed
before first use.
1. Loosen the screws of the transport safety
devices (18) using a 10 mm wrench.
(18)
2. Remove the transport safety devices (18).
(31)
3. Close the openings with the covers (31)
supplied.
4. Keep the transport safety devices in a
safe place. Re-install the transport safe-
ty devices every time the appliance is
moved – when moving home or returning
the appliance!
(18)

Installation site

The installation site must fulfil the following
conditions:
– The room must be protected against frost
and offer ventilation possibilities.
– The installation area must not be exposed
to direct sunlight. No coal- or oil-burning
heating appliances are allowed in the im-
mediate proximity.
– A water connection as well as a bath or
sink must be available.
– The mains plug must also be easily acces-
sible once the appliance has been set up.
– The ground must be secure, even, clean
and dry.
– It is not appropriate to have a rug or car-
pet under the appliance, as the appliance
will not be ventilated well enough and can
overheat.
For use on rugs, carpets, parquet or wood-
en floorboards, place a stable wooden
board (measuring at least 60 × 60 cm) un-
derneath the appliance.
If it is placed on a wooden plate or base,
the screw-on feet should be fixed so that