Kohler ENGLEFIELD EXCLUSIVE Series Installation Instructions Manual page 8

EXCLUSIVE SERIES
(b) Make sure that the edges of the return
glass panels are vertical.
(c) Drill a 2.5mm hole through the 4 small
pre-drilled holes at the top and bottom
ends of the retainers, and into the top
and bottom rail.
CAUTION
!
Be careful not to drill all the way
through the retainers.
2.5 mm
x 4
(d) Fix the corner cover clips to the retainer
using 4 pan screws
the pin on the back of the clip aligns with
the large hole at the top and bottom end
of the retainer.
PAN
ST 4.2 x 9.5mm
x 4
Clip
Round Sliding
± 0 mm
. Make sure
(supplied)
INSTALLATION INSTRUCTIONS
2.5 Door Panels
(a) Identify the door - Left or right hand.
(refer to handle location).
Note: The rollers on the top edge are
height adjustable.
(b) Hang the door panel on the top rail
from the inside of the shower.
(c) Press the button on the bottom rollers
and latch the rollers into the bottom rail.
(d) If there are gaps between the doors,
raise or lower the doors by adjusting
the screws in the top rollers (clockwise
to raise the door). Adjust so that there
are no gaps between the doors, and
the top edges are level.
Page 7
Bottom
rail
ENGLEFIELD