Kohler ENGLEFIELD EXCLUSIVE Series Installation Instructions Manual page 7

EXCLUSIVE SERIES
(f) Fix the top and bottom rails to the glass
panels. Use a power drill on a low torque
setting to drive 8 countersunk screws
into the top and bottom rails.
(supplied)
NOTE: Take care not to over tighten the screws.
COUNTERSUNK
ST 4.2 x 16mm
x 8
2.3 Retainer / Return Panel Seals
(a) Press fit 2 retainer seals into each
wall retainer. Ensure the seals are fitted
with the soft edge in contact with the
glass face.
Profile
Soft edge
of seal
Seals
Round Sliding
Wall
retainer
Return
Soft edge
of seal
Seals
INSTALLATION INSTRUCTIONS
(b) Cut the return seals to length leaving a
3-5mm notch at the bottom so that the
fexible tab overlaps the curved still
extrusion.
Profile
Notch 3-5mm of rigid portion at bottom
of seals so that the flexible tab overlaps
the sill extrusion (right hand seal shown).
(c) Press fit the return seals onto the
vertical edges of both return panels.
The flexible tab should face into the
shower.
2.4 Frame Alignment & Cover Clips
(a) Move the bottom rail forward or
backward to make sure that the gap
between the bottom rail and the front
edge of the tray is even.
=
Page 6
Flexible tab
Seals
=
=
ENGLEFIELD