Icom IC-7100 Instruction Manual page 44

3
BASIC OPERATION
Setting frequency (Continued)
D Direct frequency input (Continued)
Touch the MHz digits to enter the Band selection dis-
q
play.
Touch [F-INP]( D) to enter the Direct input screen.
w
e
ting mode.
Touch the desired number to enter the desired fre-
r
quency shift.
Touch [SPLIT] or [–SPLIT](
t
shift to the transmit frequency, and the Split function
is turned ON.
[Example]
Touch [1], [0] then [SPLIT].
Open the Direct input screen.
q
Touch the desired memory channel number.
w
memory bank A to E.
The memory channels in the other memory banks cannot
be selected.
lected. (Shown in the table to the right below.)
Touch [MEMO]( D) to select the channel.
e
the Direct input screen.
](D) or push
Direct input screen.
[Example]
Touch [2], [4] then [ENT].
Touch [1], [0], [1] then [ENT].
Touch [1], [0], [9] then [ENT].
The L, R, C or D in the instructions indicate the
part of the controller.
L: Left side, R: Right side, C: Center bottom
D: Display (Touch screen)
D) to input the frequency
(C) to exit the
MENU
-
-
Enter a "." decimal point,
or minus (–) input for Split offset
Channel
1A
Scan
edge 2A
channels
3A
144 MHz CALL1 106
Call
channels
430 MHz CALL1 108
3-12
Touch the MHz
digits
Touch [F-INP]
Shows the input
digits
Enter the Split off-
set
Enter the Memory
channel
Enter the frequen-
cy
Cancel edit
Delete entering
Input Channel Input
100 1B
102 2B
104 3B
144 MHz CALL2
430 MHz CALL2
101
103
105
107
109