Icom IC-7100 Instruction Manual page 30

2
INSTALLATION AND CONNECTIONS
er.
nication cable) and a 3rd party's GPS re-
ceiver with RS-232C Port are required.
nication..
Similar to the [PHONES/SP] jack
on the controller. Plug in an exter-
nal speaker.
3.5(d) mm/
Remotely control the transceiver using CI-V commands
Send the received audio to the PC
Input modulation (pp. 1-15, 6-8)
Send the decoded RTTY outputs to the PC
Cloning using the optional CS-7100
Remotely control using the optional RS-BA1
NOTE: By setting "ACC/USB output selection" of the
Connectors Set mode (AI sec. 17), the receiving tone
can normally be output from the [ACC] socket, and
the [USB] port can output an IF signal (12 kHz). This
is required for the Software-Defined Radio (SDR) op-
eration. The Digital Radio Mondiale (DRM) broadcast
can be received using SDR.
-
- OPC-1529R
(Optional)
⁄ ˝ plug
1
8
CLONING SOFTWARE
AH-4 (Optional)
(
-
Connect a TNC (Terminal Node Con-
troller) for packet communication.
(AI sec. 20)
Cloning between transceivers (AI sec.19)
3.5(d) mm/
(AI sec. 19)
CAUTION: DO NOT connect any device to [RE-
MOTE] when cloning using the optional CS-7100
CLONING SOFTWARE
2-6
Connect the control
cable from an op-
tional AH-4 (HF/50
MHz automatic an-
tenna tuner).
(Optional)
Connected to AH-4
(
Connect control lines
for external equipment
such as TNC or a PC.
⁄ ˝ plug
1
8
.
(AI sec. 20)