Table of Contents
Advertisement
52
www.aeg.com
Problem
The oven does not heat up.
The lamp does not operate.
The display shows F111.
The display shows an error
code that is not in this table.
Steam and condensation
settle on the food and in the
cavity of the oven.
The descaling procedure is
interrupted before it finishes.
The descaling procedure is
interrupted before it finishes.
There is no water inside the
grill- / roasting pan after the
descaling procedure.
There is dirty water on the
bottom of the cavity after
the descaling cycle.
The cleaning function is in-
terrupted before it finishes.
The cleaning function is in-
terrupted before it finishes.
Possible cause
The fuse is blown.
The lamp is defective.
The plug of the core tem-
perature sensor is not cor-
rectly installed into the sock-
et.
There is an electrical fault.
You left the dish in the oven
for too long.
There was a power cut.
The function was stopped by
the user.
You did not fill the water
drawer to the maximum lev-
el.
The grill- / roasting pan is on
a wrong shelf position.
There was a power cut.
The function was stopped by
the user.
Remedy
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali-
fied electrician.
Replace the lamp.
Put the plug of the core tem-
perature sensor as far as
possible into the socket.
• Deactivate the oven with
the house fuse or the
safety switch in the fuse
box and activate it again.
• If the display shows the
error code again, contact
the Customer Care De-
partment.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
Repeat the procedure.
Repeat the procedure.
Check if the a descaling
agent / water is present in
the water drawer body.
Repeat the procedure.
Remove the residual water
and the descaling agent
from the bottom of the
oven. Put the grill- / roasting
pan on the first shelf posi-
tion.
Repeat the procedure.
Repeat the procedure.
Advertisement
Table of Contents
