Cd Test Mode - Denon RCD-N10 Service Manual

1-6. Touch Sensor Update mode
Update the Touch Sensor firmware.
1-6.1. Starting up
Insert the AC plug while pressing button "POWER", and wait for more than 3 seconds.
Release the "POWER" button when the Power indicator turns orange and the Eject indicator turns
white.
Select the "Touch Sensor Update Mode" using the "CURSOR f / d " button, then press the "ENTER"
button to confirm.
1-6.2. Displays
(1) If the firmware is out of date
"Updating" is displayed and the update starts.
"Update Completed" is displayed when the up-date is completed.
Press the "Enter" button to exit this mode.
(2) If the firmware is up to date
"Latest Firmware" is displayed.
Press the "Enter" button to exit this mode.

1-7. CD Test mode

Test the CD mechanism.
1-7.1. Starting up
Insert the AC plug while pressing button "POWER", and wait for more than 3 seconds.
Release the "POWER" button when the Power indicator turns orange and the Eject indicator turns
white.
Select the "CD Test Mode" using the "CURSOR f / d " button, then press the "ENTER" button to con-
firm.
This mode is canceled when the power is turned off.
1-7.2. Displays
(1) "CD Test Mode" is shown on the display for 5 seconds.
CD test mode details
No. Mode
1 Disc mounting
Servo check
LD ON
FOCUS ON
2
CLV ON
TRACKING ON
READ SUB CODE
3 Pickup movement
4 STOP Servo
5 All servo on
Display adjustment values
FOCUS BALANCE
FOCUS GAIN
TRACKING BALANCE
6
TRACKING GAIN
FOCUS OFFSET
TRACKING OFFSET
RFRP
Displaying the laser current
7
Overwriting the stored data
Displaying the accumulated laser-on time
8
Reset accumulated laser on time
61
Button / Operation
"5"
"13"
Press and hold the "13" button for more than 1 second.
"0 CURSOR 1" (The pickup keeps moving while the button is pressed.)
"Source" or "2"
"CURSOR d"
"Source" (Press after all servos are turned on.)
"d CURSOR f"
"d CURSOR f"
"d CURSOR f"
"d CURSOR f"
"d CURSOR f"
"d CURSOR f"
"d CURSOR f"
"d" (Volume Up)
"13" (Press and hold for 5 seconds or more while laser current is displayed)
"f" (Volume Down)
"13" (Press and hold for 5 seconds or more while total laser-on time is displayed)