Table of Contents
Advertisement
SPECIAL MODE
Special mode setting button
b No. 1 :
Press and hold the "A" button while inserting the AC plug, then wait for 3-8 seconds. (Power indicator : orange, Eject indicator : white)
b No. 2 :
Press and hold the "A" button while inserting the AC plug, then wait for 3-13 seconds. (Power indicator : white)
b No. 3 :
Press and hold the "A" button while inserting the AC plug, then wait for 3-23 seconds. (Power indicator: white)
b No. 4:
Insert the AC plug while pressing buttons "A" and "B" together, and wait for more than 3 seconds.
b No. 5, 6:
While the power is On, hold down buttons "A" and "B" for at least 3 seconds.
No.
Mode
Selecting the Mode1 for Service-
1
related
1-1 Version Display Mode
1-2 Product mode
1-3 Protection history display mode
1-4 All Device DPMS Update mode
1-5 Touch Sensor Check mode
1-6 Touch Sensor Update mode
1-7 CD Test mode
1-8 Heatrun mode
1-9 Initialize
Factory Initialization Mode
2
(Factory Reset)
3
Firmware Factory Restore
4
Tray Lock mode
5
Network Function Reset
Selecting the Mode2 for Service-
6
related
6-1 LEGO Log Capture Mode
GFront panelH
Button A
Button B
Service mode information is selected in Service-related selection mode 1.
Power
-
Service-related modes: No. 1-1 - No. 1-9 (See
The firmware version is shown on the display. (See
↑
-
Since this mode is only for production/development, the detailed information is not provided.
↑
-
Displays the protection occurrence history. (See
↑
-
Since this mode is only for production/development, the detailed information is not provided.
↑
-
Since this mode is only for production/development, the detailed information is not provided.
↑
-
Update the Touch Sensor firmware. (See
↑
-
Test the CD mechanism. (See
↑
-
Test of CD mech. (See
↑
-
Initialize the backup data for the MCU and network module. (Settings for the Installer Setup are not initialized.)
↑
-
(See
1-9.
Initialize)
Initialize the backup data only for MCU.
(Settings for the Installer Setup are initialized) (Network function settings are not initialized.)
POWER
-
(See
2. Factory Initialization
Used when replacing the Network module.
POWER
-
(See
3. Firmware Factory
Disables the OPEN/CLOSE buttons. (See
Open / Close
Network module backup data is initialized.
POWER
BACK
(See
5. Network Function
Service mode information is selected in Service-related selection mode 2.
POWER
ENTER
Service-related modes: No. 7-1 - No. 7-2 (See
Acquires the Network Module log. The log is deleted when the Network Module is deleted.
↑
↑
(See
6-1. LEGO Log Capture
X
5
Descriptions
1. Selecting the Mode1 for
1-1. Version Display
1-3. Protection History Display
1-6. Touch Sensor Update
1-7. CD Test
mode)
1-8. Heat run
mode)
Mode)
Restore)
4. Tray Lock
mode)
Reset)
6. Selecting the Mode2 for
Mode)
GTop panelH
57
Service-related)
Mode)
Mode)
mode)
Service-related)
BACK
ENTER
Hide quick links:
Advertisement
Table of Contents
