Adjust The Volume; Activate Dsp Mode; Stop Playback - JVC TH-A30 Instructions Manual

Basic VCD/CD Operations
5
A
djust the Volume
To increase the volume, press and hold VOLUME +.
To decrease the volume, press and hold VOLUME –.
VOLUME
CAUTION:
Always set the volume to the minimum before starting any source. If
the volume is set at its high level, the sudden blast of sound energy
can permanently damage your hearing and/or ruin your speakers.
Notes:
• By pressing VOLUME + or – repeatedly, you can adjust the volume
level step by step.
• The volume level can be adjusted within 51 steps—"MIN (minimum),"
01 to 49, and "MAX (maximum)."
To turn off the sounds temporarily
From the remote control ONLY:
Press MUTING.
To restore the sound, press
MUTING again.
• Pressing VOLUME + or – also restores the sound.
6
A
ctivate DSP Mode
You can enjoy DSP modes.
DSP modes—HALL, THEATER, LIVE CLUB,
DANCE CLUB
DSP modes take effect only when you enjoy a disc recorded using
Linear PCM—the LINEAR PCM indicator lights up on the display.
To activate DSP modes
Press DSP MODE (or DSP on the front panel).
The DSP indicator lights up and the current DSP mode
appears on the display for a while.
• Each time you press the button, DSP mode changes as follows:
THEATER
Normal
indication
(canceled)
— For in-depth information about DSP modes, see "Creating
Realistic Sound Fields" on pages 21, 25, and 26.
15
TOP MENU MENU RETURN MUTING
Sound signal
indicators on the
display
DSP MODE
HALL LIVE CLUB
DANCE CLUB
Note:
Before activating DSP mode, adjust the speaker setting to bring out
the best performance from this system.
For in-depth information about adjusting the speaker setting, see
"Speaker Settings" on pages 18 and 19.
7

Stop Playback

Press 7 twice.
Playback stops completely and "VCD" or "CD"
appears on the display. (The DVD player goes
on working for 3 minutes after playback stops.)
• This system can memorize the end point even when you press 7
once. When you start playback again by pressing 3/8, playback
begins from where it has been stopped—Resume play.
To remove the loaded disc
Press 0.
"OPEN" appears on the display and the disc tray comes out.
To close the disc tray, press 0 again.
• If you do not press the button, the disc tray closes
automatically after 3 minutes.
To turn off the power (into standby)
Press STANDBY/ON AUDIO (or
STANDBY/ON on the front panel).
The illumination lamp goes off and the STANDBY
lamp lights up.
• If you press STANDBY/ON
on the front panel) while the disc tray is kept open, the disc tray
closes automatically, then the system is turned off.
• A small amount of power is consumed even in standby mode. To
turn the power off completely, unplug the AC power cord.
TUNER PRESET
STANDBY/ON
AUDIO
AUDIO (or STANDBY/ON