Select An Appropriate Progressive Mode; Activate Surround Or Dsp Mode; Stop Playback - JVC TH-A30 Instructions Manual

Basic DVD Operations
6

Select an Appropriate Progressive Mode

You can select the progressive mode according to the picture type
(film or video source).
Press PROGRESSIVE repeatedly until the
progressive mode you want appears.
• Each time you press the button, the progressive
mode changes as follows:
VIDEO MODE
AUTO MODE
Notes:
• This mode is available only when progressive scanning mode is
selected.
• For in-depth information about each progressive mode, see page 17.
7

Activate Surround or DSP Mode

You can enjoy two kinds of surround—Digital Multichannel
Surround (Dolby Digital and DTS Digital Surround) and DSP
modes.
Digital Multichannel Surround—Dolby Digital
and DTS Digital Surround
Dolby Digital or DTS Digital Surround takes effect only when you
enjoy a disc encoded with its signals—the DOLBY DIGITAL or
DTS indicator lights up on the display.
To activate Dolby Digital or DTS Digital Surround
When a disc encoded with the Dolby Digital or DTS Digital
Surround is loaded, the system detects it and starts playing the disc
automatically with Multichannel Surround activated.
– For in-depth information about surround modes, see "Creating
Realistic Sound Fields" on pages 20 and 25 .
DSP modes—THEATER, HALL, LIVE CLUB,
DANCE CLUB
DSP modes take effect only when you enjoy a disc recorded using
Linear PCM—the LINEAR PCM indicator lights up on the display.
13
PROGRESSIVE
FILM MODE
Sound signal
indicators on the
display
Sound signal
indicators on the
display
To activate DSP modes
Press DSP MODE (or DSP on the front panel).
The DSP indicator lights up and the current DSP mode
appears on the display for a while.
• Each time you press the button, DSP mode changes
as follows:
THEATER
Normal
indication
(canceled)
— For in-depth information about DSP modes, see "Creating
Realistic Sound Fields" on pages 21, 25, and 26.
Note:
Before activating surround or DSP mode, adjust the speaker setting to
bring out the best performance from this system.
For in-depth information about adjusting the speaker setting, see
"Speaker Settings" on pages 18 and 19.
8

Stop Playback

Press 7 twice.
Playback stops completely and "DVD" appears
on the display. (The DVD player goes on
working for 3 minutes after playback stops.)
• This system can memorize the end point even
when you press 7 once. When you start playback again by
pressing 3/8, playback begins from where it has been stopped—
Resume play.
To remove the loaded disc
Press 0.
"OPEN" appears on the display and the disc tray comes out.
To close the disc tray, press 0 again.
• If you do not press the button, the disc tray closes
automatically after 3 minutes.
To turn off the power (into standby)
Press STANDBY/ON AUDIO (or
STANDBY/ON on the front panel).
The illumination lamp goes off and the STANDBY
lamp lights up.
• If you press STANDBY/ON
on the front panel) while the disc tray is kept open, the disc tray
closes automatically, then the system is turned off.
• A small amount of power is consumed even in standby mode. To
turn the power off completely, unplug the AC power cord.
DSP MODE
HALL LIVE CLUB
DANCE CLUB
TUNER PRESET
STANDBY/ON
AUDIO
AUDIO (or STANDBY/ON