Cypress UNIVERSAL CAPSENSE CY3280-BMM Quick Start Manual

CY3280-BMM UNIVERSAL CAPSENSE
1
1. Insert the kit CD in the CD drive.
2. Install kit content, PSoC Designer, PSoC
Programmer, and Bridge Control Panel.
Note The hardware prerequisites for this kit are
the CY3280-20x34 Universal CapSense
Controller (UCC) board and MiniProg1
3
1. Connect MiniProg1 to the CY3280-
20x34 UCC board's ISSP connector (J1).
Connect it to your PC using a USB cable.
2. Open PSoC Programmer and click
File > File Load. Browse and load the
CY3280_20x34_PD_Project1.hex file.*
3. Click Connect; connect MiniProg1 to PC.
4. Click the Program button to program the
device.
5. Click the Toggle button to power the
board.
* Note These files are located at:
<Install directory> \Cypress\CY3280
BMM\<version>\Firmware
®
MATRIX BUTTON MODULE KIT
QUICK START GUIDE
2
1. Connect the CY3280-BMM board to the
CY3280-20x34 UCC board's P2 connector.
2. In the CY3280-20x34 board, place the
jumper on header J1 to short pins 2 and 3.
3. In the CY3280-BMM board, place the
jumper on header J2 to short pins 2 and 3.
4
1. Touch one button at a time. The
corresponding row and column LED
lights up with each touch, indicating
the button you touched.
2. If you touch more than one button,
all the LEDs are turned off because
multi touch is not supported.